Veratron NavBox Electronic Control Unit

(No reviews yet)

$451.04

Veratron

SKU:

MP-82529

UPC:

7640178720916

Dimension:

8.00 (cm) × 4.00 (cm) × 12.00 (cm) (W × H × D)

This item is temporarily out of stock.

Current Stock:

NavBox Electronic Control Unit

The AcquaLink® NavBox is the core of the AcquaLink® VDO Marine system. It acts as a CPU and signal interface. The NavBox provides a wide range of digital and analog input possibilities. It supports up to four electronic engines (J1939 or NMEA 2000®) or one analog engine. It also features two VDO Marine Sumlog® paddle wheel sensor and one analog VDO Marine Windsensor connections, so legacy VDO Marine products can be used and brought to the digital age.

NavSensor reads following analog data:

Engine Oil Pressure
Engine Oil Temperature
Engine Coolant Temperature
Transmission Oil Pressure
Fresh Water, Waste Water and Fuel Level
Voltage
Rudder Angle
Engine Frequency
Battery Current
Pyrometer

It also features a NMEA 0183 input and output port as well as a buzzer output. All received data are converted and sent to the NMEA 2000® network and to the VDO Marine Bus. This gateway function allows displaying engine, liquid level, pressure, temperature and other vital information on any compatible display on the NMEA 2000® network or on designed VDO Marine AcquaLink® gauges or TFT Displays.

The configuration of the NavBox can be done by using an AcquaLink® TFT and NavControl or by using the intuitive VDO Marine diagnostic tool.

Reverse polarity protection
NMEA 2000® certified
LED signal status indication
Aluminum base plate
Front & rear side protection rating IPX4
3x VDO Marine bus lines
1x J1939 CAN bus
1x NMEA 2000® bus
1x VDO Marine Analog Wind Sensor Input
2x VDO Marine Sumlog® Inputs
AMP Super Seal power input
26 pin AUX input (analog signals, NMEA 0183)
Operating temperature range -20°C/+70°C